Stall Test

STALL TEST

Inspection and Judgment


INSPECTION

1.Inspect the amount of engine oil. Replenish the engine oil if necessary.
2.Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is 50 to 80�C (122 to
176�F). Inspect the amount of ATF. Replenish if necessary.
3.Securely engage the parking brake so that the tires do not turn.
4.Start the engine, apply foot brake, and place selector lever in "D" position.
5.Gradually press down the accelerator pedal while holding down the foot brake.
6.Quickly read off the stall speed, and then quickly release the accelerator pedal.

CAUTION:
Never hold down the accelerator pedal for more than 5 seconds during this test.


Stall speed: Stall Speed.
7.Shift the selector lever to "N" position.
8.Cool down the ATF.

CAUTION:
Run the engine at idle for at least 1 minute.
9.Repeat steps 5 through 8 with selector lever in "R" position.

JUDGMENT OF STALL TEST






Stall test standard value position