Special Repair Requirement

INSPECTION AND ADJUSTMENT

CONFIGURATION (CAN GATEWAY) : Special Repair Requirement


1. WRITING MODE SELECTION

CONSULT Configuration
Select "Re/programming, Configuration" of CAN gateway.
When writing saved data-GO TO 2.
When writing manually-GO TO 3.

2. PERFORM "AFTER REPLACE ECU" OF "READ / WRITE CONFIGURATION"

CONSULT Configuration
Perform "After Replace ECU" of "Read / Write Configuration".
- GO TO 4.

3. PERFORM "MANUAL CONFIGURATION"

CONSULT Configuration
1.Select "Manual Configuration".
2.Touch "Next".
3.Check that the configuration has been successfully written and touch "End".
- GO TO 4.

4. CHECK ALL ECU SELF-DIAGNOSIS RESULTS

1.Erase all ECU self-diagnosis results using CONSULT.
2.Turn the ignition switch OFF.
3.Turn the ignition switch ON and wait for 2 seconds or more.
4.Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.
- WORK END