Push-Button Ignition Switch Position Indicator

PUSH-BUTTON IGNITION SWITCH POSITION INDICATOR

Description

The switch that changes the power supply position.
BCM maintains the power supply position status.
BCM changes the power supply position with the operation of the push-button ignition switch.


Component Function Check


1. CHECK FUNCTION

Check push-button ignition switch ("LOCK INDICATOR", "ACC INDICATOR" and "IGNITION ON IND") in
Active Test Mode with CONSULT.





Is the inspection result normal?
YES- INSPECTION END
NO- .


Diagnosis Procedure


1. CHECK PUSH-BUTTON IGNITION SWITCH INPUT SIGNAL

1.Turn ignition switch OFF.
2.Disconnect push-button ignition switch connector.
3.Check voltage between push-button ignition switch harness connector and ground.





Is the inspection result normal?
YES- GO TO 2.
NO-Check the following.
- 10A fuse [No.9, located in fuse block (J/B)]
- Harness for open or short between push-button ignition switch and fuse
- If NG, repair or replace fuse or harness

2. CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT

1.Disconnect BCM connector.
2.Check continuity between BCM harness connector and push-button ignition switch harness connector.





3.Check continuity between BCM harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace harness.

3. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
- INSPECTION END