Special Repair Requirement

INSPECTION AND ADJUSTMENT

SYSTEM SETTING : Special Repair Requirement


SETTING PROCEDURE


1. STEP-1

Set the vehicle to the following condition.
- Ignition position: ACC
- A/T selector lever: P position (A/T models)
- Parking brake: Applied only (M/T models)
- GO TO 2.

2. STEP-2

Press set switch and hold for more than 10 seconds, then confirm blinking of the memory switch indicator.
- Seat synchronization are ON : Memory switch indicator blink two times.
- Seat synchronization are OFF : Memory switch indicator blink once.
NOTE:
- After memory setting registration, by pushing set switch for approximately 10 seconds, memory switch indicator lamp turns 4 seconds. turns OFF, blinks 1 or 2 times, and then the switching operation is complete.
Push and hold set switch during the switching operation.
- END.