Steering Lock Unit Work Procedure

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT

STEERING LOCK UNIT : Work Procedure


1. PERFORM STEERING LOCK UNIT RECOMMUNICATING FUNCTION

1.Install steering lock unit.
2.Contact backside of registered Intelligent key* to push-button ignition switch while brake pedal is depressed, then turn ignition switch ON.
*: To perform this step, use the key that is used before performing steering lock unit replacement.
3.Maintain ignition switch in the ON position for at least 5 seconds.
4.Turn ignition switch OFF.
5.Check that the ignition switch is turned ON.
- INSPECTION END