Work Procedure (Inspection Mode 1)

INSPECTION MODE

Work Procedure (Inspection Mode 1)


CAUTION:
- Before using inspection mode 1 when the Li-ion battery level is low, in order to engage clutch 1 and charge the battery from the engine, use CONSULT "EV/HEV" "DATA MONITOR" mode and check that the "HV BATTERY LEVEL" reading is 50% or more, or else use the "Li-ion battery state of charge" in the information display on the combination meter and check that the battery level is 50% or more.
- Check that the engine coolant temperature is 70 �C (158 �F) or more before using inspection mode 1.

INSPECTION MODE 1


1. CHANGING TO INSPECTION MODE

With CONSULT
1.Turn ignition switch ON with the selector lever at the P position.
2.Select "INSPECTION MODE 1" in "ACTIVE TEST" mode of "EV/HEV".
3.Touch "ON".
4.The system changes to inspection mode 1, and the hybrid system warning lamp on the combination meter blinks.
5.Set the vehicle to READY.
Without CONSULT
1.Perform the following steps within 60 seconds.
-Turn ignition switch ON with the selector lever at the P position.
-Fully depress the accelerator pedal, then fully release it 2 times.
-While depressing the brake pedal, shift the select lever to the N position.
-Fully depress the accelerator pedal, then fully release it 2 times.
-While depressing the brake pedal, shift the select lever to the P position.
-Fully depress the accelerator pedal, then fully release it 2 times.
2.The system changes to inspection mode 1, and the hybrid system warning lamp on the combination meter blinks.
3.Set the vehicle to READY.
- END

CANCELING INSPECTION MODE 1

- Inspection mode 1 is canceled when the ignition switch turns OFF.
- Inspection mode 1 is temporarily canceled when shift the select lever from P position to D position.