Required Tools

MILLIMETER WAVE SENSOR ALIGNMENT

Required Tools

The following tools are necessary to perform the millimeter wave sensor alignment:

CAUTION:
If special service tool kit J-50808 is not available, contact techline for assistance.
- CONSULT.
Revision: March 20122013 Infiniti JX





- ICC target board.
- Position 1, with 2� top tilted toward the vehicle (1).
- Position 2, vertical (2).
- Position 3, with 2� top tilted away from the vehicle (3).





- Wheel adapter (1) [shown with laser assembly (2) installed]
(Hunter alignment rack head may be substituted).





- Laser assembly (with bi-directional laser beam) as shown in the illustration.
- Tightening knob (1)
- Power ON/OFF button (2)
- Front laser beam opening (3)
- Rear laser beam opening (4)
- Attaching shaft (5)





- Stationary target as shown in the illustration.
- Stationary target (1)
- Laser signal reception plate (2)