Operation CHARM: Car repair manuals for everyone.
Home >> Isuzu >> 1991 >> Rodeo (4WD) V6-3137cc 3.1L (CPC) >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Throttle Position Sensor >> Adjustments
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Throttle Position Sensor: Adjustments

WITHOUT "SCAN-TOOL"
1. With ignition OFF, disconnect TPS connector. Install three jumper wires between TPS and TPS harness connector. Turn ignition ON but do not start engine.
2. With a voltmeter, probe TPS connector. Connect negative lead to terminal "A" (black wire) and positive lead to terminal "B" (blue/red wire).
3. With throttle closed, voltmeter should read .42-.54 volt. If voltage is not within specification, loosen TPS mounting screws and adjust TPS until voltage is correct.
4. Tighten attaching screws and recheck voltage. Turn ignition OFF and restore TPS connection.

WITH "SCAN-TOOL"
1. Connect "Scan-Tool" to ALDL connector (located under dash) according to manufacturers instructions.
2. Turn ignition ON.
3. With throttle closed, "Scan-Tool" should read .42-.54 volt. If voltage is not within specification, loosen TPS mounting screws and adjust TPS until voltage is correct.
4. Tighten attaching screws and recheck voltage. Turn ignition OFF and disconnect "Scan-Tool".
pro multis · About Operation CHARM