Distributor Installation

NOTE: Before you install the distributor, bring the No. 1 piston to compression stroke TDC.




1. Coat a new O-ring with engine oil, then install it.
2. Slip the distributor into position.

NOTE: The lugs on the end of the distributor and their mating grooves in the camshaft end are both offset to eliminate the possibility of installing the distributor 180° out of time.

3. Install the mounting bolts, and tighten them lightly.
4. Connect the distributor connector.




5. Connect the ignition wires as shown
6. Set the timing with a timing light.
7. After setting the timing, tighten the mounting bolts.