Ignition Switch: Testing and Inspection

SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section before performing repairs or service.

Under-dash Fuse/Relay Box Removal/Installation:

1. Remove the dashboard lower cover and knee bolster.
2. Remove the access panel.

Ignition Switch Test:

3. Disconnect the switch harness 7P connector from the under-dash fuse/relay box.




4. Check for continuity between the terminals in each switch position according to the table.
5. If the continuity checks do not agree with the table, check for a bad connection between the switch and switch harness.
- If the connection is OK, replace the switch.
- If the connection isn't OK, repair as necessary, and recheck. If continuity checks still do not agree with the table, replace the switch.