Operation CHARM: Car repair manuals for everyone.
Home >> Isuzu >> 1999 >> Amigo 2WD L4-2.2L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Sensors and Switches - Computers and Control Systems >> Crankshaft Position Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor
REMOVAL

1. Disconnect the negative battery cable.
2. Remove the drive belt.




3. Remove the power steering pump and mounting-bracket from engine.



4. Disconnect electrical connector from the sensor.




5. Remove the retaining bolt and sensor from the engine block.

NOTE: Use caution to avoid any hot oil that might drip out.

INSTALLATION

1. Install the crank shaft position sensor to its position.




2. Install and tighten the mounting bolt.




3. Reinstall the power steering pump and bracket to the engine.




4. Reinstall the accessory drive belt.
5. Connect the negative battery cable.

NOTE: PCM must re-learn Crankshaft Position when the CKP sensor is replaced. Refer to CKP sensor learn mode on the Scan Tool, or Tooth Error Correction.

pro multis · About Operation CHARM