Operation CHARM: Car repair manuals for everyone.
Home >> Isuzu >> 1999 >> VehiCROSS 4WD V6-3.5L >> Repair and Diagnosis >> Wiper and Washer Systems >> Wiper Arm >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Wiper Arm: Service and Repair

Removal
1. Disconnect the battery ground cable.




2. Remove the wiper arm/blade (1).
- Pry the cap (2) off with the tip of a screwdriver.
- Remove the nut (3).

Installation
To install, follow the removal steps in the reverse order noting the following points:




1. Install wiper arm/blade.
- Before installing the wiper arm/blade (1) to the shaft, confirm that the motor stop at the auto-stop position.
- Set the wiper arm/blade so that the tips of both blades are positioned as below.

Driver side:A
About 40 mm (1.57 in) from the upper edge of the cowl cover rubber seal as shown in the figure.

Assistant side:B
About 50 mm (1.97 in) from the upper edge of the black ceramic coating as shown in the figure.

- Tighten the nuts to the specified torque.
Torque: 31 Nm (23 lb.ft)

pro multis · About Operation CHARM