Speed Sensor and Case Extension Removal

Removal Procedure
^ Tools Required
- J 29837-A Output Shaft Support Fixture





1. Remove the sensor retaining bolt (35).
2. Remove the speed sensor (36) and chamfer seal (37).





3. Remove the case extension bolts (32).
4. Remove the case extension (31) and the case extension to case seal (30).
5. Remove the output shaft sleeve (690) and the output shaft chamfer seal (691). Not all models use an output shaft sleeve (690) and chamfer seal (691).





6. Install the J 29837-A.
If the J 29837-A is not used, the output shaft (687) may fall free when the input carrier retaining ring is removed.