Assemble

Assembly Procedure
Tools Required
^ J 41352 Modular Column Holding Fixture
^ J 42640 Steering Column Anti Rotation Pin





1. Snap the electric park lock (2) onto the lock module assembly (1).





2. Install the black connector (2) into the electric park lock (1).





3. Install the upper shroud (2) onto the steering column.

Notice: Refer to Fastener Notice In Service Precautions.

4. Screw the 2 TORX (R) head screws (1) into the upper shroud (2).
Tighten
Tighten the 2 TORX (R) head screws to 1.5 Nm (13 inch lbs.).





5. Install the lower shroud onto the upper shroud in the following way:
1. Match the tab slots on the lower shroud with the locking tabs on the upper shroud.
2. Tilt the lower shroud up.
3. Slide the lower shroud forward until the locking tabs snap into the tab slots.





6. Screw the 2 pan head tapping screws (1) into the lower shroud (2).
Tighten
Tighten the 2 pan head tapping screws to 3.5 Nm (31 inch lbs.).





7. Remove J 42640 from the lower shroud.
8. Remove the steering column and J 41352 from the vise.