Headlining (SWB)

Headlining (SWB)

This illustration is based on the Soft top model.

Parts Location:

Removal

1. Disconnect the battery ground cable.
2. Remove the soft top latch (Soft top model).
- Remove two bolts.







- Remove the rear roof bracket cover (4), rear roof bracket (2) connecting with resin top (1) and rear roof trim cover (3) by removing four fixing bolts (Resin top model).







3. Remove the dome light lens.
4. Remove the dome light.
- Remove the fixing screws.
- Disconnect the dome light connector.

5. Remove the rear roof trim cover.







6. Remove the interior trim panels.
7. Remove the sunroof glass assembly.
8. Remove the sun roof handle cover and sunroof handle plate.
- Remove the screw from the cover and the three fixing nuts from the plate.

9. Remove the sunvisor.
- Remove the sunvisor fixing screws and the sunvisor holder.

10. Remove the sunroof finisher.
11. Remove the headlining.

Installation

To install, follow the removal steps in the reverse order, noting the following point.

1. In case of installing sunroof finisher (1), fit the lip (2) to the headlining surely.