Checking Pedal Height

The push rod serves as the brake pedal stopper when the pedal is fully released. Brake pedal height adjustment should be performed as follows:

Adjust Brake Pedal





1. Measure the brake pedal height after making sure the pedal is fully returned by the pedal return spring.
Pedal height must be measured after starting the engine and receiving it several times.
Pedal Free Play: 6 - 10 mm (0.23 - 0.39 inch)
Pedal Free Play: 173 - 185 mm (6.81 - 7.28 inch)

NOTE: Pedal free play must be measured after turning off the engine and stepping on the brake pedal firmly five times or more.

2. If the measured value is not within the above range, adjust the brake pedal as follows:
a. Disconnect the stoplight switch connector.
b. Loosen the stoplight switch lock nut.
c. Rotate the stoplight switch so that it moves away from the brake pedal.
d. Loosen the lock nut (1) on the push rod.
e. Adjust the brake pedal to the specified height by rotating the push rod in the appropriate direction.
f. Tighten the lock nut to the specified torque.
Torque: 20 Nm (15 ft. lbs.)





g. Adjust the stoplight switch (2) to the specified clearance (between the switch housing and the brake pedal) by rotating the switch housing.
Clearance: 0.5 - 1.0 mm (0.02 - 0.04 inch)

NOTE: While adjusting the stoplight switch, make sure that the threaded part of the stoplight switch does not push the brake pedal.

h. Tighten the stoplight switch lock nut.
i. Connect the stoplight switch connector.