Front

REMOVAL
1. Raise the vehicle and support the frame with suitable safety stands.
2. Remove the stone guard.
3. Remove wheel and tire assembly.
4. Remove nut.

CAUTION: Be careful not to break the ball joint boot.

5. Remove link.
6. Remove bracket.
7. Remove stabilizer bar.
8. Remove rubber bushing.

INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal condition are found through inspection. Check the following parts:
- Stabilizer bar
- Rubber bushing
- Link ball joint

INSTALLATION
1. Install rubber bushing.
2. Install stabilizer bar.
3. Install bracket, then tighten it to the specified torque. Torque to 25 Nm (18 ft. lbs.).
4. Install link.
5. Install nut, then tighten it to the specified torque. Torque to 50 Nm (37 ft. lbs.).