Front Door Lock Assembly

Front Door Lock Assembly And Associated Parts:

REMOVAL
1. Disconnect the battery ground cable.
2. Remove the door trim panel.
3. Remove the waterproof sheet.
Refer to Window Regulator removal procedure.
4. Raise the glass up to the uppermost position, and then remove the rear guide rail.




5. Disconnect the door lock switch connector (w/power door lock) and locking links (arrow marks positions), then remove the door lock assembly fixing screws and door lock assembly.

INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points.

1. Apply chassis grease to the lock assembly and striker moving surface.
2. Tighten the door lock assembly fixing screws to the specified torque.

Torque: 7 Nm (61 lb in)

3. Check that the door lock operates smoothly.