Disassembly and Reassembly
DISASSEMBLY1. Remove the headrest.
2. Remove the reclining knob.
3. Remove the reclining cover.
4. Remove the reclining device assembly.
- Remove the two seat cushion side fixing bolts.
- Fold the seat back and then remove the two seat back side fixing bolts.
5. Remove the seat back assembly.
- Remove the center hinge side fixing bolt.
6. Remove the center hinge sub-assembly.
- Put off the seat cushion stopper and the rear end the hog rings retaining trim cover, and then draw out the sub-assembly.
7. Remove the stopper band.
8. Remove the seat lock striker.
REASSEMBLY
To reassemble, follow the disassembly steps in the reverse order, nothing the following point.
- Loosen the rubber stopper lock nut(1). Adjust the stopper (3) 50 there is no clearance between the bottom of the stopper and the carpet(2) while you make sure the rear seat is firmly locked.
Then tighten the lock nut securely.