Rear Wiper Motor

Rear Wiper Motor

Removal

1. Disconnect the battery ground cable.
2. Remove the tailgate trim pad.
- Refer to Tailgate in Body Structure section.
3. Remove the wiper arm/blade. Refer to Rear Wiper Arm/Blade in this section.
4. Remove the rear wiper motor (1).
- Disconnect the connector.




- Remove the rear wiper motor fixing screws.

Installation

To install, follow the removal steps in the reverse order, noting the following points:
1. Before installing the wiper arm/blade (1) to the motor shaft (6), confirm that the motor stops at the autostop position.
2. Tighten the motor shaft nut (5) to the specified torque.

Torque: 10 N.m (87 lb in)




3. Tighten the wiper arm nut (3) to the specified torque.

Torque: 9 N.m (78 lb in)




4. Install the wiper arm/blade so that the wiper arm contact as shown in the figure.