Window Adjustment - Endgate Up/Down

Window Adjustment - Endgate Up/Down

Adjustment Procedure




1. Lower the end gate window to the full down position.
2. Swing the end gate open.
3. Remove the end gate window sealing strip.
4. Adjust the up/down position of the end gate window by turning the adjustment screws (1).

* To lower the top edge of the window, turn the adjustment screws clockwise.
* To raise the top edge of the window, turn the adjustment screws counterclockwise.
* Each adjustment screw must be adjusted equally, with respect to each other, within 4 mm (0.6 in).
* Each revolution of the adjustment screw moves the top edge of the window 1.25 mm (0.05 in) forward or rearward.

5. Install the end gate window sealing strip.
6. Perform end gate window relearn cycle. Refer to Window Learn Cycle - Endgate.
7. Inspect the index position of the end gate glass. A 5 mm (0.20 in) rod must not be able to pass between the rear header seal and the end gate window.