Rear Door Lock Assembly

Removal

1. Disconnect the battery ground cable.




2. Remove the pull box.
- Remove the fixing screw.




3. Remove the power window switch (1).
- Pry the power window switch and remove the connector.




4. Remove the inside handle.
- Open the screw cover and remove the screw.
- Disconnect the cable.




5. Pull the trim panel at the 7 clip positions.
- Disconnect the tweeter and courtesy light connectors.
6. Remove the pull box bracket.

7. Remove the inside lock bracket.
- Disconnect the cable.




8. Peel the waterproof sheet.
- Taking notice of the door harness, peel the waterproof sheet off the door panel carefully.




9. Remove the door lock assembly.
- Disconnect the locking link and harness connector.
- Remove the 3 fixing TORX screws and bolt.

Installation

To install, follow the removal steps in the reverse order, noting the following points.
1. Apply chassis grease to the lock assembly and striker moving surface.
2. Tighten the door lock assembly fixing screws to the specified torque.

Torque: 7 N.m (61 lb.in)

3. Check that the door lock operates smoothly.