Disabling and Enabling

Disabling The SRS

Removal
Turn the ignition switch to "OFF" and turn the steering wheel so that the vehicle's wheels are pointing straight ahead.

1. Remove SRS fuse METER and SRS, from left dash side lower fuse block or disconnect battery.
2. Disconnect yellow 2-pin connector at the base of steering column.
3. Remove glove box assembly; refer to Passenger Air Bag Assembly Replacement in this section.
4. Disconnect passenger air bag assembly yellow 2-pin connector behind the glove box assembly.

With the "SRS" fuse removed and ignition switch "ON," the "AIR BAG" warning lamp will be "ON." This is normal operation and does not indicate an SRS malfunction.

Enabling The SRS

Installation
Turn ignition switch to "LOCK" and remove key.
1. Connect yellow 2-pin connector passenger air bag assembly.
2. Install glove box assembly, Refer to Passenger Air Bag Assembly Replacement in this section.
3. Connect yellow 2-pin connector at the base of the steering column.
4. Install "AIR BAG" fuse SRS-1 to left dash side lower fuse block or connect battery.

Turn ignition switch to "ON" and verify that the "AIR BAG" warning lamp flashes seven times and then turns "OFF" If it does not operate as described, perform the "SRS Diagnostic System Check" in this section.