Door Emblem and Nameplate Replacement (Canyon)

Door Emblem and Nameplate Replacement (Canyon)

Tools Required

J 25070 Heat Gun

Removal Procedure

Important: Use the tape for protection and alignment marks for alignment of the new emblem.

1. Apply tape to the area around the door emblem.
2. Heat the emblem/nameplate, using a J 25070,152 mm (6 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.

Notice: Refer to Exterior Trim Emblem Removal Notice.

4. Remove the emblem/nameplate from the door surface using a plastic, flat-bladed tool.




5. Remove all adhesive from the door panel surface and the back of the emblem/nameplate using 3M(TM) scotch brite molding adhesive remover disk 3M(TM) P/N 07501 or equivalent.
6. Clean the door surface using varnish makers and painters (VMP) naphtha.

Installation Procedure




1. If the location of the emblem/nameplate has not been marked, apply tape and use the following dimensions:
* Dimension (a) is 251 mm (9.88 in) from the bottom of the door to the emblem/nameplate.
* Dimension (b) is 157 mm (6.18 in) from the front of the door to the front of the emblem/nameplate.

2. Warm the door surface with a J 25070,152 mm (6 in) from the surface to a minimum of 21�C (70�F).

Important: Do not touch the adhesive backing of the emblem/nameplate.

3. Remove the backing from the front end of the emblem/nameplate.
4. Press the emblem/nameplate to the door panel surface while continuing to remove the backing.
5. Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
6. Inspect the emblem/nameplate for bonding.
7. Remove the tape from the area around the door emblem.