Headlining Trim Panel Replacement (Crew Cab)

Headlining Trim Panel Replacement (Crew Cab)

Removal Procedure

1. Remove the right front door.
2. Remove the front seats.
3. Remove the rear seat.
4. Remove the windshield garnish moldings.




5. Disconnect the headliner harness (1) from the body harness (2).
6. Remove the lower center pillar trim panel.
7. Remove the upper center pillar trim panel.
8. Remove the lower body rear corner trim panels.
9. Remove the upper body rear corner trim panels.
10. Remove the dome lamp.
11. Remove the sunshades.
12. Remove the assist handles and the driver assist handle or assist handle blank.
13. Remove the coat hooks.




14. Tilt the steering wheel to the full down position.
15. If equipped with a manual transmission, place the transmission in 2nd gear and remove the shift knob handle.
16. Remove the 2 push pins securing the headliner to the row bow.
17. Remove the 2 rear push pins from the headliner. Replace any damaged push pin spacers.
18. Lower the forward edge of the headliner.
19. Standing at the left front door, grasp the headliner at the dome lamp opening and at the headliner's left edge.




20. Slide the headliner forward and under the steering wheel.




21. Rotate the forward edge of the headliner towards the right front door opening ensuring that the left edge of the headliner is behind the shift knob stem.




22. Remove the headliner from the vehicle through the right front door opening.

Installation Procedure




1. Install the headliner in the vehicle through the right front door opening, rear edge first.




2. Slid the headliner into the vehicle towards the left side of the cab ensuring that the left edge of the headliner is behind the shift knob stem.




3. Rotate the rear edge of the headliner towards the rear of the cab with the forward edge of the headliner under the steering wheel.
4. Ensure that the roof rail air bag tethers will not be obstructed by the installed headliner.
5. Raise the headliner into position and install the 2 rear push pins into the roof.
6. Install the 2 push pins securing the headliner to the row bow.
7. Install the headliner above the door weather strips.
8. Install the inboard sunshade retainers.
9. Install the sunshades.
10. Install the assist handles and the driver assist handle or assist handle blank.
11. Install the coat hooks.
12. Install the dome lamp.
13. Install the upper body rear corner trim panels.
14. Install the lower body rear corner trim panels.
15. Install the upper center pillar trim panel.
16. Install the lower center pillar trim panel.




17. Connect the headliner harness (1) to the body harness (2).
18. Install the windshield garnish moldings.
19. Install the rear seat.
20. Install the front seats.
21. Install the right front door.