Knock Sensor 2 Replacement
Knock Sensor 2 ReplacementRemoval Procedure
NOTICE: The knock sensor 2 is located on the right side of the engine (passenger side).
1. Raise vehicle and suitably support the vehicle.
2. Unsnap the heat shield around the knock sensor 2 electrical connector and move out of the way.
3. Disconnect the knock sensor 2 electrical connector.
4. Remove the knock sensor 2 bolt and remove knock sensor 2 .
Installation Procedure
NOTICE: Fastener Notice
1. Position the knock sensor 2 so the electrical connector faces the 4-5 o'clock position and install the attachment bolt.
Tighten
Tighten the bolt to 25 N.m (18 lb ft)
2. Connect the knock sensor 2 electrical connector.
3. Reinstall the heat shield over the knock sensor 2 electrical connector making sure to connect the button.
4. Lower the vehicle.