Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor Replacement

Removal Procedure

WARNING: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

NOTE: Perform the Crankshaft Position System Variation Learn when the CKP sensor is removed or replaced. Programming and Relearning






1. Disconnect the negative battery cable.
2. Raise the vehicle. Vehicle Lifting Caution
3. Remove the starter.






4. Disconnect the crankshaft position (CKP) sensor electrical connector.






5. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
6. Remove the CKP sensor retaining fastener.
7. Remove the CKP sensor.

Installation Procedure
1. Install the CKP sensor.

CAUTION: Fastener Notice






2. Install the CKP sensor retaining fastener

Tighten
The fastener to 25 N.m (18 lb ft).






3. Connect the CKP sensor electrical connector.






4. Install the starter.
5. Lower the vehicle.
6. Connect the negative battery cable.
7. Perform the CKP system variation learn procedure. Programming and Relearning