Rear Door Window Motor: Service and Repair

Remove and Refit

- Remove the door casing and arm-rest. Service and Repair

- Disconnect the battery.





- Disconnect the cables from the motor at the plug and socket connection (1, Fig. 33).

- Remove the four pan-headed setscrews and detach the regulator mechanism from the door panel (2, Fig. 33).

- Adjust the position of the door until the regulator arm can be removed from the channel. Withdraw the regulator through the aperture in the door.

- If it is necessary, remove the glass in order to withdraw the regulator.

- Withdraw the three setscrews and washers and detach the motor from the regulator. The motor is sealed during manufacture. Faulty units must be replaced, no service repair being possible.

- Refitting is a reversal of the above procedure.