Blower Assembly - Driver Side
Blower Assembly - Driver SideRemoval
1. Open the bonnet and disconnect the battery earth lead.
2. Remove the left hand side dash liner.
3. Remove the lower screw securing the central processor, displace the earth lead and remove the spacers.
4. Loosen the upper screw securing the processor, raise and disengage the processor from the securing screw.
5. Displace the processor downwards for access.
6. Remove the screws securing the processor mounting bracket and remove the bracket.
7. Remove the screws securing the blower motor assembly.
8. Disconnect the multi-plug cable connectors.
9. Disconnect the vacuum hose from the blower motor assembly servo unit.
10. Disconnect the pliable trunking from the air conditioning unit.
11. Displace and remove the blower motor assembly.
12. Remove the rubber gasket from the assembly.
13. Remove the screws securing the ambient temperature sensor and remove the sensor.
NOTE: Installation is the reverse of the removal procedure.