Pinpoint Test G239843P33

PINPOINT TEST G239843p33 : CHECK THE SUPPLIES AND GROUNDS TO THE DYNAMIC STABILITY CONTROL MODULE (DSCCM)

G239843t106 : CHECK THE PERMANENT SUPPLIES TO THE DSCCM
1. Disconnect the DSCCM electrical connector, EC30.
2. Measure the voltage between EC30, pins 01 (NR) and 32 (NW) and GROUND.

- Is the voltage less than 10 volts?

-> YES
REPAIR the circuit between the DSCCM and battery. This circuit includes the front power distribution box (fuses 20 and 22). TEST the system for normal operation.

-> NO
GO to Pinpoint Test G239843t107.

G239843t107 : CHECK THE IGNITION SUPPLY TO THE DSCCM
1. Turn the ignition switch to the ON position.
2. Measure the voltage between EC30, pins 04 (W) and GROUND.

- Is the voltage less than 10 volts?

-> YES
REPAIR the circuit between the DSCCM and battery. This circuit includes the primary junction box (fuse 17) and the ignition switch. TEST the system for normal operation.

-> NO
CHECK for DTCs indicating a network or module fault. REFER to the DTC index.