Navigation Display: Service and Repair

Navigation System Display Module

Removal
1 Disconnect the battery ground cable. For additional information, refer to Specifications




2 Remove the instrument panel center reinforcement trim panel.
- Release from the 5 clips.




3
CAUTION: Protect the surrounding trim from damage when changing the component.
Release the navigation system module bracket.
- Remove the 4 Torx screws.
- Disconnect the 10 electrical connectors.
- Release the assembly.




4
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the navigation screen module.
- Remove the trim panel veneer upper retaining clip.
- Remove the 2 Torx screws.
- Remove the 4 Torx bolts.

Installation
1 Install the navigation screen module.
- Tighten the Torx bolts to 6 Nm (4 lb.ft).
- Tighten the Torx screws.
- Install the clip.
2 Install the navigation system module bracket.
- Connect the electrical connectors.
- Tighten the Torx screws.
3 Install the instrument panel center reinforcement trim panel.
- Align the pegs and secure with the clips.
4 Connect the battery ground cable. For additional information, refer to Specifications