Procedures

HOUSING ASSEMBLY

REMOVAL
1. Move glass panel to the fully closed position.
2. Disconnect battery negative cable
3. Recline both front seats.
4. Remove headliner.

Fig. 7 Sunroof Assembly:

5. Disconnect the drain tubes from sunroof housing.
6. Loosen fasteners attaching sunroof housing assembly.
7. With the aid of a helper, remove fasteners attaching sunroof housing assembly to roof panel.

INSTALLATION
1. Raise the sunroof housing assembly and guide into position and start fasteners.
2. Tighten the fasteners, front to rear, attaching the sunroof module to roof panel. Tighten the fasteners, front to rear, to 11 Nm (97 in. lbs.) torque.
3. Connect the drain tubes to the sunroof housing.
4. Set headliner into position.
5. Connect express module, drive motor, and control switch wire connectors.
6. Test sunroof operation, adjust as necessary.
7. Finish installing the headliner.
8. Connect battery negative cable.