Seat Riser - Installation

INSTALLATION

Manual Length Adjuster





1. Before proceeding with the following repair procedure, review all warnings and cautions. Service Precautions

NOTE: Passenger seat with strain gauges shown, drivers side seat similar.

2. If equipped, install the strain gauges and install the bolts (2).
3. Tighten the bolts to 40 Nm (30 ft. lbs.).
4. If necessary, connect the electrical connections (1).
5. Move the seat to the forward position on the tracks and install the rear seat adjuster bolts/nuts (3).
6. Tighten the bolts to 45 Nm (33 ft. lbs.).
7. Move the seat to the reward position on the tracks and install the front seat adjuster bolts/nuts (3).
8. Tighten the bolts to 45 Nm (33 ft. lbs.).
9. Install the seat. Service and Repair

Power Length Adjuster





1. Before proceeding with the following repair procedure, review all warnings and cautions. Service Precautions
2. If equipped, install the strain gauges and install the bolts (2).
3. Tighten the bolts to 40 Nm (30 ft. lbs.).
4. Position the seat into the vehicle onto the risers and connect the electrical connectors.
5. Move the seat to the forward position on the tracks and install the seat adjuster bolts/nuts (3).
6. Tighten the bolts attaching the adjuster to the risers/strain gauges to 45 Nm (33 ft. lbs.).
7. Move the seat to the reward position on the tracks and install the front seat adjuster bolts/nuts (3).
8. Tighten the bolts attaching the adjuster to the risers/strain gauges to 45 Nm (33 ft. lbs.).
9. If necessary, connect the strain gauge electrical connections (1).

CAUTION: When the motor and cable assembly are removed from the tracks discard the length adjuster assembly and replace with a new one.

10. Bolt the seat to the floor. Service and Repair