Electronically Controlled Clutch - Installation

INSTALLATION





1. Apply RTV to the EEC mounting surface.
2. Install wave washer.
3. Slide ECC into rear axle.
4. Install the four ECC mounting bolts and tighten to 68 Nm (50 ft. lbs.).
5. Plug the electrical connector (3) in.
6. Connect the breather hose to EEC.
7. Install the EEC Harness routing bracket bolt and tighten to 14 Nm (124 in. lbs.).
8. Install the rear propeller shaft Propeller Shaft - Installation.
9. Install the exhaust system Installation.