Rear Brake Hose

REAR BRAKE HOSE





1. Install the brake hose (3) to the mounting hole at the frame and install the mounting bolt (2).
2. Install the brake line tube nut (1) to the brake hose (3) and tighten to 23 Nm (200 in. lbs.) torque.





3. Install banjo bolt (2) attaching brake hose (1) to caliper. Install NEW washers on each side of hose fitting as banjo bolt is placed through banjo fitting. Thread banjo bolt into caliper and tighten to 31 Nm (23 ft. lbs.) torque.
4. Lower vehicle.
5. Remove the prop rod from the vehicle.
6. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed.Service and Repair.