Service Procedure

A. Replace Oxygen Sensor:





1. Locate the oxygen sensor in the exhaust manifold as shown in Figure 1.

2. Disconnect the oxygen sensor electrical connector.

3. Remove the oxygen sensor.

4. Clean the exhaust manifold threads using a thread chaser.

NOTE:
Do not use solvents or lubricants on threads.

5. Install provided oxygen sensor. Tighten to 22 ft.lbs. (30 N-m).

6. Connect oxygen sensor electrical connector.

B. Install Recall Completion Label:

1. With a ball point pen, print your dealer code (5 digits) on the supplied Recall Completion Label.

2. Peel the label from its backing and apply it near the Vehicle Emissions Control Information Label on the underside of the hood.

C. Complete Proof of Correction Form:

1. Complete a Vehicle Emission Recall Proof of Correction Form and supply it to the vehicle owner.