Power Steering Pressure Switch: Service and Repair

The content of this article reflects changes called for in TSB 26-10-96.

POWER STEERING PRESSURE SWITCH

Fia. 40 Power Steering Pressure Switch:

The power steering pressure switch is installed in the power steering high-pressure hose (line) (Fig. 40).

REMOVAL

1 Disconnect electrical connector from power steering pressure switch.

2 Place a small container or shop towel beneath switch to collect any excess fluid.

3 Remove switch. Use a back-up wrench on power steering line to prevent bending fine.


INSTALLATION

1 Install power steering switch into power steering line.

2 Tighten to 14-22 Nm (124-195 in.lbs.)torque.

3 Connect electrical connector to switch.

4 Check power steering fluid and add as necessary

5 Start engine and again check power steering fluid. Add fluid if necessary