Programming Blank Sentry Keys With the DRB

Programming Blank Sentry Keys With The DRB
When programming a blank Sentry Key transponder, the key blank must first be cut to match the ignition lock cylinder. It will also be necessary to enter the vehicle's 4-digit PIN code into the DRB to enter the SKIM's secured access mode.

NOTE: ONCE A SENTRY KEY IS PROGRAMMED TO A PARTICULAR VEHICLE IT CANNOT BE TRANSFERRED TO ANOTHER VEHICLE.

Insert the blank key into the ignition and turn it to the Run/Start position. Using the DRB select "Theft: Alarm", then "SKIM", then "Miscellaneous". Select "Program New Key." Enter the 4-digit PIN code using the DRB. When programming is completed, the SKIM will exit secured access mode and display the status of the key. The different status messages are (programming successful, learned key in ignition, maximum key limit exceeded, programming riot attempted or programming failed).

"Programming Successful" is displayed if SKIM Sentry Key programming succeeds.

"Learned Key in Ignition" is displayed if the key in the ignition has already been programmed into that vehicle's SKIM.

"8 Keys Already Learned (At The Maximum) Programming Not Done" is displayed if eight keys have already been programmed into the SKIM. In this case, if a new key needs to be added due to a lost or defective key, the "Erase All Keys" function (requires entering secured access mode) has to be performed. Then the customer's seven keys plus the new key MUST be reprogrammed into the SKIM.

"Programming Key Failed" is displayed if further diagnosis is required.

To learn additional keys, turn the ignition OFF, remove the learned key, and insert the next new blank key. Turn ignition to the Run position and re-enter the secured access mode function and repeat the "Program New Key" procedure outlined above.