Powertrain Verification Test - Ver 1
VERIFICATION TEST VER-1Applicability - All
1. If PCM has been changed and correct VIN and mileage have not been programmed, a DTC will be set in ABS and Airbag modules. In addition, if vehicle is equipped with a Sentry Key Immobilizer Module (SKIM), Secret Key data must be updated to enable start.
2. For ABS and Airbag systems: Enter correct VIN and Mileage in PCM. Erase codes in ABS and Airbag modules.
3. For SKIM theft alarm: Connect DRB to data link connector. Go to Theft Alarm, SKIM, Misc. and place SKIM in secured access mode, by using the appropriate PIN code for this vehicle. Select Update the Secret Key data, data will be transferred from SKIM to PCM.
4. Inspect the vehicle to ensure that all engine components are connected. Reassemble and reconnect components as necessary. Inspect the engine for contamination. If it is contaminated, change the oil and filter.
5. Attempt to start the engine.
6. If the engine is unable to start, look for any Technical Service Bulletins that may relate to this condition. Return to Symptom List if necessary.
7. If the engine starts and stays running, the repair is now complete.