Latch Striker

LATCH STRIKER

REMOVAL

1. Remove headlamp bezel.
2. Remove parklamp.
3. Release the spring attaching the headlamp mounting bucket to the grille opening panel (GOP).
4. Remove the headlamp with mounting bucket attached from the adjusting screws.
5. Remove the upper bolt attaching the striker to the top of the (GOP).
6. Remove the lower bolt attaching the striker to the (GOP).
7. Remove the striker and shims.

INSTALLATION

1. Position the shims and striker on the (GOP) and install the bolts.
2. Install the headlamp and mounting bucket.
3. Install parklamp.
4. Install the headlamp bezel.
5. Test the striker/hood alignment by opening and closing the hood several times. Adjust the striker, if necessary.