Leak Detection Pump: Service and Repair

Fig. 9 EVAP Canister Purge Solenoid (With LDP):

The LDP is located in the right-rear side of engine compartment. The LDP filter is located above the LDP. The LDP and LDP filter are replaced (serviced) as one unit.

REMOVAL
1. Carefully remove hose at LDP filter.
2. Remove LDP filter mounting bolt and remove from vehicle.
3. Carefully remove vapor/vacuum lines at LDP.
4. Disconnect electrical connector at LDP.
5. Remove 2 LDP mounting screws and remove from vehicle.

INSTALLATION
1. Install LDP to mounting bracket. Tighten screws to 1 Nm (11 in. lbs.) torque.
2. Install LDP filter to mounting bracket. Tighten bolt to 7 Nm (65 in. lbs.) torque.
3. Carefully install vapor/vacuum lines to LDP, and install hose to LDP filter. The vapor/vacuum lines and hoses must be firmly connected. Check the vapor/vacuum lines at the LDP, LDP filter and EVAP canister purge solenoid for damage or leaks. If a leak is present, a Diagnostic Trouble Code (DTC) may be set.
4. Connect electrical connector to LDP.