Parking Pawl: Service and Repair

REMOVAL
1. Remove valve body.

Fig. 88:

2. Remove bolts attaching park rod bracket to case (Fig. 88).

Fig. 89:

3. Remove park rod from manual valve shaft sector (Fig. 89).
4. Remove park rod.

Fig. 91:

5. Remove park pawl, pin and spring (Fig. 90).

INSTALLATION
1. Examine park rod, pawl, pin and spring. Replace any component that is worn or damaged.
2. Install pawl in case. Insert pin and install spring. Be sure spring is positioned as shown in Figure 35.
3. Install park rod and bracket (Fig. 88). Tighten bracket bolts to 10 Nm (7 ft. lbs.) torque.
4. Install valve body, oil screen and oil pan.