Windshield Washer Reservoir: Service and Repair

REMOVAL AND INSTALLATION
1. Disconnect end isolate the battery negative cable.

Washer Reservoir Filler Neck Remove/Install:

2. The washer reservoir filler neck is held in the reservoir by an interference fit. Remove the filler neck from the reservoir using a combination of pulling, rocking and twisting actions.
3. Remove the engine air filter housing.

Washer Reservoir Remove/Install:

4. Remove the two screws that secure the washer reservoir to the inner fender shield.
5. Raise and support the vehicle.
6. Remove the left front inner wheelhouse splash shield.
7. Remove the washer supply hose(s) from the washer pump(s) end drain the washer fluid from the reservoir into a clean container for reuse.
8. Unplug the wire harness connectors from the washer pump(s) and the washer fluid level sensor.
9. Slide the reservoir slightly towards the rear of the vehicle to release the two hooks from the inner fender ledge slots.
10. Lower the front of the washer reservoir and slide the unit forward to remove it from the vehicle.
11. Reverse the removal procedures to install. Tighten the reservoir mounting screws to 3 Nm (26 in. lbs.).