Wiper Relay: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.

Power Distribution Center:

2. Remove the cover from the Power Distribution Center (PDC).
3. See the fuse and relay layout label affixed to the underside of the PDC cover for wiper high/low relay and wiper on/off relay identification and location.
4. Remove the wiper high/low relay or wiper on/off relay from the PDC.

INSTALLATION
1. See the fuse and relay layout label affixed to the underside of the PDC cover for the proper wiper high/low relay or wiper on/off relay location.
2. Position the wiper high/low relay or wiper on/off relay in the proper receptacle in the PDC.
3. Align the wiper high/low relay or wiper on/off relay terminals with the terminal cavities in the PDC receptacle.
4. Push down firmly on the wiper high/low relay or wiper on/off relay until the terminals are fully seated in the terminal cavities in the PDC receptacle.
5. Install the cover onto the PDC.
6. Reconnect the battery negative cable.