Power Locks: Testing and Inspection

Following are tests that will help to diagnose the hard wired components and circuits of the power lock system. However, these tests may not prove conclusive in the diagnosis of this system. In order to obtain conclusive testing of the power lock system, the Programmable Communications Interface (PCI) data bus network and all of the electronic modules that provide inputs to, or receive outputs from the power lock system components must be checked.

The most reliable, efficient, and accurate means to diagnose the power lock system requires the use of a DRB scan tool and the proper Diagnostic Procedures. The DRB scan tool can provide confirmation that the PCI data bus is functional, that all of the electronic modules are sending and receiving the proper messages on the PCI data bus, and that the power lock motors are being sent the proper hard wired outputs by the door modules for them to perform their power lock system functions.

Preliminary Diagnosis
As a preliminary diagnosis for the power lock system, note the system operation while you actuate both the Lock and Unlock functions with the power lock switches and with the Remote Keyless Entry (RKE) transmitter. Then, proceed as follows:
- If the entire power lock system fails to function with either the power lock switches or the RKE transmitter, check the fused B(+) fuse in the Power Distribution Centre. If the fuse is OK, refer to Door Module.
- If the power lock system functions with both power lock switches, but not with the RKE transmitter, refer to Remote Keyless Entry System.
- If the power lock system functions with the RKE transmitter, but not with one or both power lock switches, refer to Door Module.
- If the driver side power lock switch operates only the driver side front door power lock motor, but all other power lock motors operate with the passenger side power lock switch or the RKE transmitter, use a DRB scan tool and the proper Diagnostic Procedures to diagnose the Programmable Communications Interface (PCI) data bus.
If only one power lock motor to operate with both power lock switches and the RKE transmitter.