Rear

REMOVAL
1. Raise and fold rear seat forward. Then move carpeting aside for access to rear sensor connectors.






2. Disconnect rear sensor wire at harness connectors).
3. Push sensor wires and grommets through floorpan holes.
4. Raise and support the vehicle.
5. Disengage sensor wire from axle and chassis brackets and from brake line retainers.






6. Remove the sensor mounting bolt from the rear brake backing plate.
7. Remove sensor from the backing plate.

INSTALLATION






1. Insert sensor through the backing plate.
2. Apply Mopar Lock N' Seal or Loctite(TM) 242 to original sensor bolt. Use new bolt if original is worn or damaged.
3. Tighten sensor bolt to 12 - 14 Nm (106 - 124 inch lbs.).
4. Secure sensor wire in brackets and in retainers on rear brake lines. Verify that sensor wire is secure and clear of rotating components.
5. Route sensor wires to rear seat area.
6. Feed sensor wires through floorpan access hole and seat sensor grommets in floorpan.
7. Remove support and lower the vehicle.
8. Fold rear seat and carpet forward for access to sensor wires and connectors.
9. Connect sensor wires to harness connectors.
10. Reposition carpet and fold rear seat down.