Backup Lamp: Service and Repair

REMOVAL
1. From the underside of the vehicle, remove the push-in fastener attaching the bottom rear edge of the rear wheelhouse splash shield to the body.
2. Pull the rear of the wheelhouse splash shield away from the body and reach upward to disengage the tail lamp electrical connector.
3. Remove the screws attaching the lens to the tail lamp housing.

Tail Lamp Housing:

4. Remove the bolts attaching the tail lamp housing to the body.
5. Separate the lamp housing from the body.

INSTALLATION
1. Engage the electrical connector.
2. Install the push-in fastener attaching the bottom rear edge of the rear wheelhouse splash shield to the body.
3. Position the lamp housing on the body.
4. Install the bolts attaching the tail lamp housing to the body.
5. Install the screws attaching the lens to the tail lamp housing.