Daytime Running Lamp Control Unit: Service and Repair

Fig.7 Daytime Running Lamp Module:

REMOVAL
The Daytime Running Lamp (DRL) module is located on the right fender inner panel adjacent to the dash panel.
1. Disconnect and isolate the battery negative cable.
2. Disconnect the headlamp and dash wire harness connector for the DRL module from the module connector receptacle.
3. Remove the screws that secure the DRL module to the fender inner panel.
4. Remove the DRL module from the fender inner panel.

INSTALLATION
1. Position the DRL module onto the right fender inner panel.
2. Install and tighten the screws that secure the DRL module to the right fender inner panel.
3. Reconnect the headlamp and dash wire harness connector for the DRL module to the module connector receptacle.
4. Reconnect the battery negative cable.