Front Wiper Module Assembly

DISASSEMBLY
The front wiper motor and its rubber boot are available for service replacement. Following are the procedures for disassembling these components from the front wiper module unit.
1. Remove the front wiper module from the cowl plenum. (Refer to ELECTRICAL/FRONT WIPERS/WASHERS/FRONT WIPER MODULE - REMOVAL).
2. Release the retainer that secures the wiper motor pigtail wire connector to the front wiper module bracket.
3. Turn the front wiper module over and remove the nut that secures the wiper motor crank arm to the wiper motor output shaft.
4. Remove the three screws that secure the wiper motor to the front wiper module mounting bracket.
5. Remove the wiper motor from the front wiper module bracket.

ASSEMBLY
The front wiper motor and its rubber boot are available for service replacement. Following are the procedures for reassembling these components onto the front wiper module unit.
1. Position the wiper motor onto the front wiper module bracket.
2. Install and tighten the three screws that secure the wiper motor to the front wiper module bracket. Tighten the screws to 8 Nm (70 in. lbs.).
3. Position the wiper motor crank arm onto the front wiper motor output shaft.
4. Install and tighten the nut that secures the wiper motor crank arm to the front wiper motor output shaft. Tighten the nut to 12 Nm (101 in. lbs.).
5. Engage the wiper motor pigtail wire connector retainer in the locating hole on the front wiper module bracket.
6. Reinstall the front wiper module into the cowl plenum. (Refer to ELECTRICAL/FRONT WIPERS/WASHERS/FRONT WIPER MODULE - INSTALLATION).