Front Lamp Unit

REMOVAL
1. Disconnect and isolate the battery negative cable

Fig.19 Front Fog Lamp Unit Remove/Install:

2. Remove the screw that secures the outboard end of the front lamp unit to the front bumper fascia.
3. Pull the outboard end of the front lamp unit away from the front bumper fascia far enough to disengage the tab on the inboard end of the front lamp unit housing from the receptacle in the fascia.
4. Pull the front lamp unit away from the front bumper fascia far enough to access and disconnect the wire harness connector(s) for the front lamp unit from the lamp socket pigtail wire(s).
5. Remove the front lamp unit from the front bumper fascia.

INSTALLATION
1. Position the front lamp unit to the front bumper fascia.
2. Reconnect the wire harness connector(s) for the front lamp unit to the lamp socket pigtail wire(s).
3. Engage the tab on the inboard end of the front lamp unit housing into the receptacle in the front bumper fascia.
4. Position the outboard end of the front lamp unit housing to the front bumper fascia.
5. Install and tighten the screw that secures the outboard end of the front lamp unit housing to the front bumper fascia. Tighten the screw to 2 Nm (20 in. lbs.).
6. Reconnect the battery negative cable.